CT75A Capacity Tester
A UK-based helicopter manufacturer wanted high capacity testing capability for their helicopter batteries and, finding nothing readily available on the open market they came to Intelligent Charging Limited for a special unit.
As a result of the above requirement, Intelligent Charging Limited designed and built this new capacity testing unit to add to our extensive range of intelligent battery charging and capacity testing products. With up to 100.0A capacity testing capability, this model will satisfy the most demanding aviation battery.
Using similar ‘intelligence’ to the MB73P+ range, but without any charge capability, the CT75A has all the same features of cell monitoring, process mode operation, cell balancing and hard copy of capacity test results using the external printer.
Capacity test 12.0V batteries up to 100.0A
Capacity test 24.0V batteries up to 80.0A
Input Voltage maximum 40.0V
Input Watts maximum 2KW
Cell Monitoring and Cell Balancing using the cell monitor
Process mode can be used to capacity test and follow on with cell balance
External printer to provide hard copy of test results
Universal input voltage 85-264VAC, 120-300VDC, 47-440Hz, 25W Max
Product Details for CT75A
Operationally the same as the MB73P+ models but without any charge capability the CT75A has all the same features of cell monitoring, process mode operation, cell balancing and hard copy of capacity test results using the external printer.
- Capactiy Test To 100%
- Capacity Test To Target voltage
- Capacity Test With Cell Monitor (With TH20 Cell Monitor)
- Capacity Test To Target Or Time
- Automatic Cell Balance (With TH20 Cell Monitor)
- Full Discharge
- Capacity Test 12V At 100A
- Capacity Test 24V At 80A
- Intuitive Data Entry
- Only Three Keystrokes Needed To Start
- Can Be Set So A Predefined Test Can Be Scheduled To Start Later
- Audio Alarm To Indicate Process Completion Or Failure
- Internally Protected From Overloads
- Reverse Or No Battery Connection Protected
- Automatically Shuts Down If Battery Disconnected During Operation
- Battery Volts, Amps & Time Displayed On A Clear Display
- Shows Calibration Status
- Can Control The Brightness Of The Display
- L. 44.3cm x W. 34.6cm x H. 31.45cm (L. 17.44 x W. 13.62 x H. 12.38 Inches)
- 19Kg (42Lbs)
- Built In Printer For Audit Trail
- Allows Individual Cell Monitoring Using TH20 Cell Monitor Accessory
- Input Voltage 85-264VAC, 47-440Hz, 120 – 370VDC
- Bench Mounted
- Supplied With 1 Set Of Leads 100cm Long With 8mm Ring Crimps
- Alternative Or Longer Lead Sets Available
- 1 Year RTB Warranty